1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
|
Installation
Preliminary installation instructions for rpkid et al.
These are the production-side RPKI tools, for Internet Registries
(RIRs, LIRs, etc). See ../rcynic/README for relying party tools.
rpkid is a set of Python modules supporting generation and maintenance
of resource certificates. Most of the code is in the rpkid/rpki/
directory. rpkid itself is a relatively small program that calls the
library modules. There are several other programs that make use of the
same libraries, as well as a collection of test programs.
At present the package is intended to be run out of its build
directory. Setting up proper installation in a system area using the
Python distutils package would likely not be very hard but has not yet
been done.
Note that initial development of this code has been on FreeBSD, so
installation will probably be easiest on FreeBSD.
The first step to running the code is to build the OpenSSL and POW
binaries. At present the OpenSSL code is just a copy of the stock
OpenSSL 0.9.8g release, compiled with special options to enable RFC
3779 support that ISC wrote under previous contract to ARIN. The POW
(Python OpenSSL Wrapper) library is an extended copy of the stock POW
release.
To build these, cd to the top-level directory in the distribution and
type "make".
$ cd $top
$ make
This should automatically build everything, in the right order,
including staticly linking the POW extension module with the OpenSSL
library to provide RFC 3779 support.
Next, see the list of required Python modules in rpkid/README. Note
that the Python code requires Python version 2.5. Install any modules
that might be missing.
You will also need a MySQL installation. This code was developed using
MySQL 5.1 and has been tested with MySQL 5.0 and 5.1.
The architecture is intended to support hardware signing modules
(HSMs), but the code to support them has not been written.
At this point, you should have all the necessary software installed.
You will probably want to test it. All tests should be run from the
rpkid/ directory.
Some of the tests require MySQL databases to store their data. To set
up all the databases that the tests will need, run the SQL commands in
rpkid/testbed.sql. The MySQL command line client is usually the easiest
way to do this, eg:
$ cd $top/rpkid
$ mysql -u root -p <testbed.sql
To run the tests, run "make all-tests":
$ cd $top/rpkid
$ make all-tests
If nothing explodes, your installation is probably ok. Any Python
backtraces in the output indicate a problem.
__________________________________________________________________
Generated on Thu Jun 12 18:21:05 2008 for RPKI Engine by doxygen
1.5.5
|
